Tyco Network Card AS0073 001 User Manual

D A T A s h e e T  
Input/Output Modules  
Features That Make a Difference:  
Provides cost-effective expansion of input and output capacity  
Compatible with full range of Software House® iSTAR and apC  
access control panels  
Locate modules up to 1,220 m (4,000 ft) away from controllers using  
flexible two-wire RS-485 RM bus  
Reduces length of sensor and control wiring to save installation  
costs  
I8 provides eight Class A supervised inputs  
R8 provides eight Form C relay outputs  
I8-CSI, configurable supervised input model, allows use of existing  
input wiring without changing end-of-line (EOL) resistors  
Three status LEDs per input (red/yellow/green) and one per output  
enable quick diagnostics and troubleshooting  
Small, modular size requires minimal panel space  
Dedicated tamper input included on each module  
Optional UL-listed enclosure available  
The Software House I8, R8, and I8-CSI modules provide a  
flexible, cost-effective means to expand the input and output  
functionality of any iSTAR or apC access controller. Common  
applications include alarm monitoring and control and elevator  
control.  
The R8 output module provides eight Form C dry contact relay  
outputs. A red status LED per output shows the state of the  
relay.  
All modules feature a dedicated input for an external cabinet  
tamper switch and mount easily in the Software House RM-CAN  
or RM-DCM-CAN enclosure. The modules communicate with  
iSTAR or apC controllers via the two-wire RM bus that allows  
total wiring distances of up to 1,220 m (4,000 ft). Up to eight I8s  
and eight R8s can be connected to each apC, iSTAR eX, and  
iSTAR Pro eight-reader model; up to 16 of each module can be  
connected to the iSTAR Pro 16-reader model.  
The I8 input module provides eight Class A supervised inputs.  
Three LEDs per input help the installer commission and  
troubleshoot each input circuit – red if the input is in alarm,  
green for normal, and yellow for a supervision error. LEDs may  
be turned off via a DIP switch setting.  
The I8-CSI module enhances the functionality of the standard  
I8 module by supporting numerous supervised circuit types and  
EOL resistance values. This allows the I8-CSI to accommodate  
existing field wiring without changing EOL resistors. More  
than 20 different circuit types are supported. The circuit type  
is selected via a bank of DIP switches and applies to all eight  
inputs on the I8-CSI.  
The modules are fully compatible with both C•CURE® 800/8000  
and C•CURE 9000.  
 

Telit Wireless Solutions Network Hardware UC864 User Manual
Tiger Games 36287 User Manual
Toshiba Cash Register MA 71 User Manual
Toshiba Digital Camera IK WB11 User Manual
Toshiba Scanner MR 3018 User Manual
Troy Bilt Edger 554 User Manual
United States Stove Heat Pump DR6 User Manual
Vivotek Home Security System FD8164 User Manual
Vornado Patio Heater EH1 0091 06 User Manual
Wayne Dalton Automobile Electronics 3966 User Manual